Cisco 3515 MCU24 Manuale Utente Scaricare il pdf (Pagina 13)

CHAPTER

2-1

Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU12 and MCU 24 Releases 5.6 and 5.7

OL-17012-01

Setting Up Your Cisco Unified

Videoconferencing 3515 MCU

• Physical Description, page 2-1

• Verifying the Package Contents, page 2-2

• Mounting the Cisco Unified Videoconferencing 3515 MCU Unit in a 19-inch Rack, page 2-3

• How to Perform the Cisco Unified Videoconferencing 3515 MCU Unit Initial Configuration,

page 2-4

• How to Perform the Video Processing Module Initial Configuration, page 2-8

• About Managing and Monitoring the Cisco Unified Videoconferencing 3515 MCU Unit, page 2-13

• Accessing the Cisco Unified Videoconferencing 3515 MCU Administrator Interface, page 2-13

• Registering the Online Help for the 3515 MCU, page 2-15

Physical Description

Each Cisco Unified Videoconferencing 3515 MCU unit internally contains two cards:

• Signaling and audio card (MCU—the upper card)

• Video processing card (EMP—the lower card)

The two cards work together to perform audio and videoconferencing, but each card requires a unique

IP address. The cards communicate with each other using IP as the backbone.

Note For correct operation, the EMP card must register with the MCU.

This section provides a physical description of the Cisco Unified Videoconferencing 3515 MCU12 and

Cisco

Unified Videoconferencing 3515 MCU24 units.

The Cisco Unified Videoconferencing 3515 MCU unit has a 10/100BaseT Ethernet port on the front

panel that uses an RJ-45 connector to connect to the network. There is an asynchronous, 9-pin serial-port

that you can use with a hyperterminal program to configure and monitor the module.

Figure 2-1 shows the front panel of the Cisco Unified Videoconferencing 3515 MCU unit. Table 2-1

describes the components of the front panel.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

Nessun commento

Cisco 3515 MCU24 Manuale Utente Pagina 13