Cisco GoQAM Informazioni Techniche Scaricare il pdf (Pagina 174)

Cha

5 ICIM Mode Commands

150 4025561

Rev

user add

Syntax

user add username authlevel accountstatus

Description

The user add command is used to add a new login and password to the ICIM2

authentication table. A dialog is used to obtain and validate the password.

Parameters

The username, or user identifier, must be 6 to 14 characters in length and contain

both letters and numbers. The username cannot include special characters. An

example of a valid username is abc123.

The authlevel, or authorization level, may be one of the following:

authlevel Description

Admin Equivalent to a Unix superuser (root) and should be allowed for

only the most trusted logins. An Admin can change passwords, IP

addresses, and other critical values.

Readwrite Allows typical operations, including the ability to change control

values and alarm parameters.

Read Allows the user to read non-critical values only, and has no write

permissions.

The accountstatus may be one of the following:

accountstatus Description

Enable The account is enabled.

Disable The account is created but disabled.

Note: After entering this command, you will be prompted to enter a password for

the user. The password must be 6 to 14 characters in length and contain both letters

and numbers. Unlike the username, the password may contain special characters.

Access Rights Required

Admin

1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 307 308

Nessun commento

Cisco GoQAM Informazioni Techniche Pagina 174