Cisco Network Convergence System 6000 Series Guida di Installazione Scaricare il pdf (Pagina 8)

5-8

Cisco Network Convergence System 6000 Series Routers Hardware Installation Guide

Chapter 5 Installing Route Processor Cards, Line Cards, and Fabric Cards

Installing a Route Processor Card

Prerequisites

Before performing this task, open the cosmetic doors, if installed. The RP cards are hot-swappable.

Caution Install one RP card at a time. Allow at least 15 seconds for the chassis to complete its tasks before

installing another RP card. The chassis may indicate a hardware failure if you do not follow proper

procedures.

Required Tools and Equipment

• ESD-preventive wrist strap

• Number-2 Phillips screwdriver or number-2 common (flat-head) screwdriver

• RP card (Cisco PID NC6-RP)

Steps

To install an RP card (Figure 5-3), perform the following steps:

Step 1 Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the two ESD jacks

on the rear side of the chassis (Figure 2-4). You can also connect the ESD-preventive wrist strap leash

to any bare metal surface on the chassis.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Nessun commento

Cisco Network Convergence System 6000 Series Guida di Installazione Pagina 8