Cisco NM-16ESW - EtherSwitch Switch Manuale Utente Scaricare il pdf (Pagina 84)

Configuring the Cisco Gigabit EtherSwitch EHWIC

Configuration Examples for Gigabit EtherSwitch EHWICs

Configuring the Cisco Gigabit EtherSwitch EHWIC

OL-23155-01

Switched Port Analyzer (SPAN) Source: Examples

This section provides the following configuration examples:

• SPAN Source Configuration: Example, page 84

• SPAN Destination Configuration: Example, page 84

• Removing Sources or Destinations from a SPAN Session: Example, page 84

SPAN Source Configuration: Example

The following example shows SPAN session 1 being configured to monitor bidirectional traffic from

source interface Gigabit Ethernet 0/1/1:

Router(config)#monitor session 1 source interface gigabitethernet 0/1/1

SPAN Destination Configuration: Example

The following example shows interface Gigabit Ethernet 0/1/7 being configured as the destination for

SPAN session 1:

Router(config)#monitor session 1 destination interface gigabitethernet 0/1/7

Removing Sources or Destinations from a SPAN Session: Example

This following example shows interface Gigabit Ethernet 0/1/2 being removed as a SPAN source for

SPAN session 1:

Router(config)#no monitor session 1 source interface gigabitethernet 0/1/2

IGMP Snooping: Example

The following example shows the output from configuring IGMP snooping:

Router#show mac-address-table multicast igmp-snooping

EHWIC Slot: 1

--------------

MACADDR VLANID INTERFACES

0100.5e05.0505 1 Gi0/1/1

0100.5e06.0606 2

EHWIC Slot: 2

--------------

MACADDR VLANID INTERFACES

0100.5e05.0505 1 Gi0/3/4

0100.5e06.0606 2 Gi0/3/0

Router#

The following is an example of output from the sh run int privileged EXEC command for VLAN 1:

Router#show run int vlan 1

Building configuration...

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 90

Nessun commento

Cisco NM-16ESW - EtherSwitch Switch Manuale Utente Pagina 84