Cisco PSUS4 Guida Utente Pagina 23
- Pagina / 58
- Indice
- RISOLUZIONE PROBLEMI
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
16
Chapter 6: Configuring the PrintServer
Overview
PrintServer for USB with 4-Port Switch
Chapter 6: Configuring the PrintServer
Overview
The PrintServer has been designed to be functional right out of the box with the default settings in the Setup
Wizard. However, if you’d like to change these settings, you can use the PrintServer ’s web-based utility. This
chapter will describe each web page in the utility and each page’s key functions. The utility can be accessed via
your web browser through the use of a computer.
To access the web-based utility, launch Internet Explorer or Netscape Navigator, and enter the PrintServer ’s IP
address in the Address field. Then press Enter.
There are five main tabs: Setup, Protocol, Printer, Status, and Exit. Additional tabs will be available after you click
one of the main tabs.
The Setup Tab
The first screen that appears displays the Setup tab. (See Figure 6-1.) This screen allows you to change the
PrintServer 's general settings. Change these settings as described here and click the Save button to apply your
changes or click Cancel to cancel your changes.
PSUS4 Device Name. Enter the PrintServer’s name in the field. The name can be located on a sticker that is on
the bottom of the PrintServer.
Password. To change the PrintServer’s password, enter the Current Password in the field. Enter the New
Password in the field, then enter the new password again in the Verify Password field.
Protocols. Check the box(es) for AppleTalk or NetBEUI, as they apply to your network.
Change these settings as described here and click the Save button to apply your changes or click Cancel to
cancel your changes.
Figure 6-1: Setup
NOTE: Use the PrintServer’s IP address that you noted during the Setup Wizard.
Otherwise, insert the Setup CD-ROM, and when the Welcome screen appears, click on
Setup Wizard. Follow the instructions until you reach the third screen, (refer to Chapter
4, Figure 4-3) where the IP address will be shown. After you note the IP address, click
Back until you reach the Welcome screen of the Setup Wizard. Click Exit.
- PrintServer for USB 1
- How to Use this User Guide 2
- Copyright and Trademarks 2
- Table of Contents 3
- List of Figures 5
- Chapter 1: Introduction 10
- What’s in this Guide? 10
- The Back Panel 11
- The Front Panel 12
- The Side Panel 12
- Overview 13
- Installation 14
- The Setup Tab 23
- The Protocol Tab - TCP/IP 24
- The Protocol Tab - Apple Talk 24
- The Protocol Tab - NetBEUI 25
- The Status Tab - Device 28
- The Status Tab - Printer 28
- The Exit Tab 29
- Windows IPP Client Setup 30
- Using IPP Printers 32
- Bi-Admin Installation 34
- Menu Options 37
- Appendix A: Troubleshooting 44
- Appendix A: 45
- Common Problems and Solutions 45
- Appendix D: Windows Help 48
- Appendix E: Glossary 49
- Appendix F: Specifications 55
Bos manuels
La liste des produits de Bos contient 57 les manuels et guides d'utilisation des modèles 49 dans les appareils de type 2
Commenti su questo manuale