Cisco ATM Cable Interface Processor ACIP-SM(=) Specifiche Pagina 6
- Pagina / 32
- Indice
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
6 ATM Cable Interface Processor (ACIP) Installation and Configuration
ACIP Description
Table 2 Typical Fiber-Optic Link Attenuation and Dispersion Limits
Approximating the ACIP Power Margin
The LED used for a multimode transmission light source creates multiple propagation paths of light,
each with a different path length and time requirement to cross the optical fiber, causing signal
dispersion (smear). Higher order mode loss (HOL) results from light from the LED entering the fiber
and being radiated into the fiber cladding. A worst case estimate of power margin (PM) for
multimode transmissions assumes minimum transmitter power (PT), maximum link loss (LL), and
minimum receiver sensitivity (PR). The worst case analysis provides a margin of error, although not
all of the parts of an actual system will operate at the worst case levels.
The power budget (PB) is the maximum possible amount of power transmitted. The following
equation lists the calculation of the power budget:
PB = PT – PR
PB = –18.5 dBm – (–30 dBm)
PB = 11.5 dB
The power margin calculation is derived from the power budget minus the link loss, as follows:
PM = PB – LL
If the power margin is positive, as a rule, the link will work.
Table 3 lists the factors that contribute to link loss and the estimate of the link loss value attributable
to those factors.
Table 3 Estimating Link Loss
After calculating the power budget minus the data link loss, the result should be greater than zero.
Results less than zero may have insufficient power to operate the receiver.
Limits Multimode
Attenuation 1.0 dB/km
Dispersion 500 MHzkm
1
1. The product of bandwidth and
distance must be less than 500
MHzkm.
Link Loss Factor Estimate of Link Loss Value
Higher order mode losses 0.5 dB
Clock recovery module 1 dB
Modal and chromatic dispersion Dependent on fiber and wavelength used
Connector 0.5 dB
Splice 0.5 dB
Fiber attenuation 1 dB/km
- Installation and Configuration 1
- ATM Terms and Acronyms 2
- ACIP Description 4
- ACIP Interface 5
- SONET Distance Limitations 5
- • 4 connectors 7
- • 3 splices 7
- • Higher order loss (HOL) 7
- • Clock recovery module (CRM) 7
- ACIP Software Prerequisites 9
- ROUTE SWITCH PROCESSOR 2 10
- RX Carrier 17
- RX Cells 17
- Configuring the ACIP 21
- Configure an ACIP Interface 22
- Configure Cable Parameters 23
- Configuration Example 25
- Monitor and Maintain the ACIP 25
- ACIP Error Statistics 26
- Checking the Configuration 26
- Using the Debug ATM Commands 27
- • 0x8000—IP panic 29
- • 0x4000—CD state change 29
- • WWW: http://www.cisco.com 32
- • Telnet: cco.cisco.com 32
Prodotti e manuali riguardandi Processori Cisco ATM Cable Interface Processor ACIP-SM(=)
(50 pagine)Kenwood MFJ-286 manuali
Manuali dei proprietari e guide per l'utente per Microfoni Kenwood MFJ-286.
We fornisce 1 manuali pdf Kenwood MFJ-286 per scaricare gratuitamente in base al tipo di documento: Manuale Utente
Commenti su questo manuale