Cisco 600W Manuale Utente Scaricare il pdf (Pagina 10)

Figure 8 Redundant-with-Reboot Configuration

Figure 9 Mixed Configuration

Cable Connection Procedures

Before connecting to external devices, read the power warnings below. Cisco recommends that you disconnect all power before

beginning.

Note You can connect an additional external device to a Cisco RPS that is already powered up without interrupting power

to the Cisco RPS or to any other connected external devices. Be sure to connect your cable to the Cisco RPS first and

then to the external device. However, in a redundant-with-reboot configuration, to ensure proper operation, you must

power up the switch or hub before powering up the Cisco RPS. Therefore, always connect the switch to AC before you

connect it to the Cisco RPS. Failure to follow the proper power-up sequence can result in incorrect LED displays.

External devices

150W or less

DC output

AC power cords

AC power strip

AC input

isco RPS

12052

Quasi-RedundantFully redundant

AC input

isco RPS

11681

DC output

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Nessun commento

Cisco 600W Manuale Utente Pagina 10