Cisco InfiniBand 4x Guida Utente Scaricare il pdf (Pagina 67)

Chapter 4. Configuring InfiniBand with QLogic bridges 53

5. Open the Web interface of your bridge module and click SRP Initiator Discovery, then

click Start on the upper, right side of the page as shown in Figure 4-21. The SRP initiators

that you created should be discovered and displayed under Discovered Hosts.

Figure 4-21 SRP Initiator Discovery screen

The following components are used to identify your virtual SRP initiator:

– GUID: InfiniBand HCA Port GUID that is being used for the virtual HBA.

– Extended SRP ID: The initiatorExtension that was set in the ics_srp.cfg file.

6. Click Configure to designate a name for the initiator (Figure 4-22). You will use this name

later when mapping to a storage target.

Figure 4-22 Assign a name to the initiator.

7. After a name has been designated, click Submit. The initiator moves from Discovered

Hosts to Configured Initiators (Figure 4-23).

Figure 4-23 Configured Initiators

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 173 174

Nessun commento

Cisco InfiniBand 4x Guida Utente Pagina 67