
9
Special Considerations
Installing a Card
Every time you install a card in a slot of the system, use this procedure:
Step 1 Log in to the active NP as root. (See the Software Upgrade Procedures for instructions for
identifying the active NP.)
Step 2 To see the current flash checksums of all cards in the chassis, enter the following command:
bash# sysver -a | more
The correct checksums are as follows:
Network Processor: Flash Image Checksum: 0xC1DE
Switch Card 1: Flash Image Checksum: 0x5D00
Switch Card 2: Flash Image Checksum: 0x64A2
Low Speed Card: Flash Image Checksum: 0x181C
Medium Speed Card: Flash Image Checksum: 0xA7FC
Packet Line Card: Flash Image Checksum: 0x0339
Cell Line Card: Flash Image Checksum: 0xE782
Note The label Switch Card 1 denotes Release 1 of the switch card, and the label Switch Card 2
denotes Release 2 of the switch card.
Step 3 If a line card or NP flash checksum is not correct, load the flash into the card by using the
following command:
bash# fcload -s
slot#
-flash -force
Here, slot# represents the slot number of the card with the incorrect flash checksum.
If a new switch card has an incorrect flash checksum, load the flash by following the
procedure described in “Procedure 4, Verify Switch Card Flash.”
Step 4 Verify flash again (Step 1 and Step 2 above).
Step 5 If the card still has an incorrect flash checksum the flash is loaded, contact Cisco Customer
Support.
Other Special Considerations
The special considerations in this section are provided with a Cisco case number. If you contact
Cisco about any of these special considerations, please refer to the case number.
Severity Level 2 Problems
LIGle00213 CLI
CLI does not allow you to set bandwidth parameters for virtual circuits to defaults.
Use the values specified in the LightStream 2020 Configuration Guide.
Commenti su questo manuale