Cisco RSP4+ Bootflash Memory Upgrade to 16MB MEM-16F-RSP4+= Manuale Utente Scaricare il pdf (Pagina 14)

RSP4+ Bootflash Memory Upgrade to 16MB Installation and Configuration Guide

78-12288-02

Installing the SIMM

Note When inserting SIMMs, use firm but not excessive pressure. If you damage a socket, you

will have to return the RSP4+ to the factory for repair.

Step 5 Gently push the SIMM into the socket until the spring clips snap over the ends of the SIMM. If

necessary, rock the SIMM gently back and forth to seat it properly. (See Figure 7.)

Figure 7 Inserting Vertically-Loaded SIMMS

Step 6 Confirm that the SIMM is properly seated. If the SIMM is properly seated, the socket guide posts

should insert through the alignment holes, and the connector springs should click into place. If the

SIMM appears misaligned, carefully remove it and reseat it in the socket. Push the SIMM firmly back

into the socket until the spring clips snap into place.

This completes the new SIMM installation procedure.

2. Push the SIMM down and back.

1. Insert the SIMM into the socket at an angle 45° from vertical.

The socket guide posts insert

through the SIMM holes

(on both sides).

The locking spring will

clip the back of the SIMM

when it is fully installed

(on both sides).

H1152

Top view

Front of the chassis

Polarization

notch

1. Insert the SIMM into the socket at an angle 45° from vertical.

The socket guide posts insert

through the SIMM holes

(on both sides).

The locking spring will

clip the back of the SIMM

when it is fully installed

(on both sides).

Side view

2. Push the SIMM down and back.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Nessun commento

Cisco RSP4+ Bootflash Memory Upgrade to 16MB MEM-16F-RSP4+= Manuale Utente Pagina 14