Cisco Router IOS XR Manuale Utente Scaricare il pdf (Pagina 54)

Cisco IOS XR Training Page 54

D 2.2.2.2/32 [90/130816] via 150.1.12.2, 00:00:11, GigabitEthernet0/3/0/2

C 150.1.12.0/24 is directly connected, 01:30:45, GigabitEthernet0/3/0/2

L 150.1.12.1/32 is directly connected, 01:30:45, GigabitEthernet0/3/0/2

RP/0/7/CPU0:R1#

There, we have a route to R2’s loopback. Lets PING it from our loopback to

test connectivity.

RP/0/7/CPU0:R1#ping 2.2.2.2 so l0

Thu Mar 29 20:09:36.232 UTC

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 2.2.2.2, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 2/2/5 ms

RP/0/7/CPU0:R1#

And like that basic EIGRP is done.

Now, lets add IPv6 to the EIGRP process.

RP/0/7/CPU0:R1#conf t

Thu Mar 29 20:27:16.966 UTC

RP/0/7/CPU0:R1(config)#router eigrp 1

RP/0/7/CPU0:R1(config-eigrp)#address-family ipv6

RP/0/7/CPU0:R1(config-eigrp-af)#int l0

RP/0/7/CPU0:R1(config-eigrp-af-if)#int g0/3/0/2

RP/0/7/CPU0:R1(config-eigrp-af-if)#commit

Thu Mar 29 20:27:28.352 UTC

RP/0/7/CPU0:R1(config-eigrp-af-if)#

I will be honest here; the correct command to show routes is show route

Protocol. Once you add IPv6, you really should to start to use the correct

commands. 

RP/0/7/CPU0:R1#sh route ipv6

Thu Mar 29 20:29:31.952 UTC

Codes: C - connected, S - static, R - RIP, B - BGP

D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area

N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2

E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP

i - ISIS, L1 - IS-IS level-1, L2 - IS-IS level-2

ia - IS-IS inter area, su - IS-IS summary null, * - candidate default

U - per-user static route, o - ODR, L - local, G - DAGR

A - access/subscriber, (!) - FRR Backup path

Gateway of last resort is not set

L 2001::1/128 is directly connected,

00:58:42, Loopback0

D 2001::2/128

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 104 105

Nessun commento

Cisco Router IOS XR Manuale Utente Pagina 54