Cisco Router IOS XR Manuale Utente Scaricare il pdf (Pagina 60)

Cisco IOS XR Training Page 60

Ok, that worked – now we can do the same for IPv6. First we should look at

the IPv6 IS-IS routes and then ping the loopback of R2.

RP/0/7/CPU0:R1#sh route ipv6 isis

Thu Mar 29 22:17:43.918 UTC

i L2 2001::2/128

[115/20] via fe80::2d0:79ff:fe01:3a78, 00:07:05, GigabitEthernet0/3/0/2

RP/0/7/CPU0:R1#ping 2001::2 so 2001::1

Thu Mar 29 22:17:49.763 UTC

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 2001::2, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 3/9/34 ms

RP/0/7/CPU0:R1#

Compare that to IOS ISIS config:

Configure the process and set the level and NET

R1(config)#router isis

R1(config-router)#net 49.0000.0000.0001.00

R1(config-router)#is-type level-2

Then change context to the G0/1 interface and enable ISIS for IPv4 and IPv6

R1(config-router)#int g0/1

R1(config-if)#ip router isis

R1(config-if)#ipv6 router isis

Then change context to the Loop0 interface and enable ISIS for IPv4 and IPv6

R1(config-if)#int l0

R1(config-if)#ip router isis

R1(config-if)#ipv6 router isis

R1(config-if)#^Z

Few more steps, and configuring things under the process make much more sense

than under an interface.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 104 105

Nessun commento

Cisco Router IOS XR Manuale Utente Pagina 60