Cisco 15310-MA Guida alla Risoluzione dei Problemi Pagina 319

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
Vedere la pagina 318
4-11
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0
78-18394-01
Chapter 4 Error Messages
EID-2143 No online help version was selected.
The online help book cannot be deleted.
Select the version of online help, and
proceed.
EID-2144 An error occurred while deleting the online help book(s).
{0}
You cannot delete the specified online help.
EID-2145 No nodes appear to have a Cisco IOS card. Refer to error message.
EID-2146 This is a security violation.
You may only logout of your own account.
You cannot logout of an account other than
your own.
EID-2147 This is a security violation.
You may only change your own account.
You cannot change an account other than
your own.
EID-2148 This is a security violation.
You cannot delete the account under which you are currently
logged in.
You cannot delete the account you are
currently logged in.
WID-2149 There is no exportable content in this view. Refer to the error message text.
WID-2150 The node {0} is not initialized.
Please wait and try again.
Wait till the specified node is initialized and
try again.
WID-2152 Spanning tree protection is being disabled for this circuit. Refer to the warning message text.
WID-2153 Adding this drop will make the circuit a PCA circuit. Refer to the warning message text.
WID-2154 Monitor circuits cannot be created on a port grouping circuit. Refer to the warning message text.
WID-2155 Switch counts might not be fully supported on some nodes.
{0}
The specified nodes do not support switch
counts completely.
WID-2156 The manual roll mode is recommended for dual rolls.
For auto dual rolls, please verify that roll to facilities are in
service and error-free.
Refer to the warning message text.
WID-2157 The roll(s) cannot be completed.
{0}
CTC could not complete the roll because
the roll is destroyed, in an incomplete state,
in a TL1_roll state, is cancelled, or is not
ready to complete.
EID-2158 The roll mode is invalid.
{0}
There are two roll modes: auto and manual.
For a one-way circuit source roll, the roll
mode must be auto and for a one- way
circuit destination roll, the roll mode must
be manual.
EID-2159 The roll is not ready for completion.
{0}
The roll is not ready for completion.
EID-2160 The roll is not connected.
{0}
Refer to error message text.
Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message Description
Vedere la pagina 318
1 2 ... 314 315 316 317 318 319 320 321 322 323 324 ... 379 380

Commenti su questo manuale

Nessun commento