
4-52
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0
78-18394-01
Chapter 4 Error Messages
EID-6263 The equipment requires two slots. The user provisions a double footprint card
in a single slot.
EID-6264 The patchcord is duplicated. Refer to the error message text.
EID-6265 The wavelength is in use by an OCH trail, a virtual link, or an
internal patchcord.
Refer to the error message text.
EID-6266 The card cannot be changed because the port has not been
provisioned.
Refer to the error message text.
EID-6267 Each port can have a maximum of 8 MAC addresses. Refer to the error message text.
EID-6268 This server trail does not have a valid start or end. Refer to the error message text.
EID-6269 The maximum number of server trails is 3743. Refer to the error message text.
EID-6270 A unique server trail ID could not be allocated. Refer to the error message text.
EID-6271 The server trail already exists. Refer to the error message text.
EID-6272 The server trail size must not exceed the port bandwidth. Refer to the error message text.
EID-6273 An OCH Trail circuit is active on the trunk port.
To modify the ITU-T G.709 parameter, the circuit must be out
of service.
Refer to the error message text.
EID-6274 Unable to restore this database:
The software version cannot be obtained from the node. Please
try again.
The user tries to restore a database on a
node, but its not possible to get the software
version from it.
EID-6275 You cannot change this parameter.
The port is part of an active circuit.
Certain parameters like Port Rate and
Admin State cannot be changed when the
port is part is part of an active circuit.
Delete all the circuits on the port before
changing admin state of the port.
EID-6276 APC is disabled. APC Correction Skipped. Override cannot be
performed.
Refer to the error message text.
EID-6277 There are no alarm conditions available to run APC Correction
Skipped Override.
Refer to the error message text.
EID-6278 APC Correction Skipped Override is not supported for this card. Refer to the error message text.
EID-6279 Protection cannot be disabled when the FPAS alarm is active. Refer to the error message text.
WID-6280 Any configuration change will be lost and the operation is traffic
affecting.
Refer to the error message text.
EID-6281 The port is involved in a protection group.
The protected port is not in the {0} administrative state
Change the port state to administrative.
WID-6282 Forcing FPGA update will be traffic-affecting. Refer to the error message text.
WID-6283 Enabling ALS on a DWDM trunk port that is connected to a
channel filter
will result in a conflict with the ALS on the amplifier card or with
the
VOA startup process. Is it OK to continue?
Refer to the error message text.
Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message Description
Commenti su questo manuale